LCD messageAppears on the floating kit and here · keeps the last 10
LCD
s
Switch settings
Input names
Cycle
Network
IP address
—
Port
—
Gateway
—
Mask
—
A wrong value here makes the switch unreachable over the network. There is no factory reset; recovery needs an RS232 cable. You will be asked to confirm twice.
Change the switch's address
Warning 1 of 2
These values will be written to the switch now and used after its next power cycle:
A wrong IP address, port, gateway, or mask makes the switch unreachable over the network.
There is no factory reset for these settings. Recovery is only possible with a serial (RS232) cable.
Warning 2 of 2
You do this at your own risk.
This software sends the values exactly as entered. It cannot check that they are valid for your network, cannot undo the change, and cannot recover a switch that is no longer reachable.
This software and its authors accept no liability for any loss, damage, downtime, or cost that results from changing these settings.
Setting
Requested
Switch reports
Connect info
Listener
—
HDMI switch
—
mDNS name
—
Samples
There is no authentication on the listener. Use these addresses only on a network you trust.