Station
Reading station status.
Reading station status.
Connect the saved port, or use the mock arm without hardware.
Connect to calibrate skips the saved motor range.
Do this once per adapter.
Only this adapter should disappear.
No port found yet.
Plug it back in, then save.
Set each joint's midpoint, then move every joint except wrist roll through its travel and save the limits.
Connect to calibrate first if the arm has no saved range. Motion stays locked until a range is stored.
The agent is the only camera client.
Loading camera profiles.
No stream
A D405 uses the intrinsics in its profile. Another RealSense reads them from the device once the vision extra is installed. Demo is synthetic and needs no hardware.
Connect the arm and the camera on Hardware.
Ten fixed poses. The arm moves by itself, so keep the area clear.
Connect the arm and the camera, then turn torque on.
Settle with one AprilTag in view, then capture.
Four poses minimum, spread about two rotation axes.
Hold the 8 by 11 board in view. Tilt it across the image. Ten views required.
Read from the camera when it opens. Demo uses fixed values.
Hold a key or button. Esc stops.
Gripper: —.
Relative to the arm base frame. Yaw is the EE heading around the base Z axis. Pitch is the tilt from level in that heading, and positive points the fingers down. Roll is the twist around the EE.
| Joint | Deg | Limits |
|---|
Click the table. A newer click cancels the move.
No click yet.
Click the image.
No pick yet.
Click inside a box. The arm picks its centre.
Detection: reCamera.
No pick yet.
When boxes overlap, the smallest one under the click is selected.
| Label | Score | Centre px |
|---|