      -------------------------------------------------------------------
                        STM32CubeProgrammer v2.23.0                  
      -------------------------------------------------------------------

ST-LINK SN  : 0054003D3137511139383538
ST-LINK FW  : V3J17M11
Board       : NUCLEO-H743ZI
Voltage     : 3.28V
SWD freq    : 8000 KHz
Connect mode: Hot Plug
Reset mode  : Software reset
Device ID   : 0x450
Revision ID : Rev V
Device name : STM32H7xx
NVM size    : 2 MBytes
Device type : MCU
Device CPU  : Cortex-M7
BL Version  : 0x90


UPLOADING OPTION BYTES DATA ...

  Bank          : 0x00
  Address       : 0x5200201c 
  Size          : 308 Bytes

[==================================================] 100% 


OPTION BYTES BANK: 0

   Read Out Protection:

     RDP          : 0xAA (Level 0, no protection) 

   BOR Level:

     BOR_LEV      : 0x0 (reset level is set to VBOR0) 

   User Configuration:

     IWDG1_SW     : 0x1 (Independent watchdog is controlled by software) 
     NRST_STOP_D1 : 0x1 (STOP mode on Domain 1 is entering without reset) 
     NRST_STBY_D1 : 0x1 (STANDBY mode on Domain 1 is entering without reset) 
     FZ_IWDG_STOP : 0x1 (Independent watchdog is running in STOP mode) 
     FZ_IWDG_SDBY : 0x1 (Independent watchdog is running in STANDBY mode) 
     SWAP_BANK    : 0x0 (after boot loading, no swap for user sectors) 
     IO_HSLV      : 0x0 (Product working in the full voltage range, I/O speed optimization at low-voltage disabled) 

   Boot address Option Bytes:

     BOOT_ADD0    : 0x800  (0x8000000) 
     BOOT_ADD1    : 0x1FF0  (0x1FF00000) 

   PCROP Protection:

     PROT_AREA_START1: 0xFF  (0x800FF00) 
     PROT_AREA_END1: 0x0  (0x80000FF) 
     DMEP1        : 0x0 (Flash Bank 1 PCROP zone is kept when RDP level regression (change from level 1 to 0) occurs) 
     PROT_AREA_START2: 0xFF  (0x810FF00) 
     PROT_AREA_END2: 0x0  (0x81000FF) 
     DMEP2        : 0x0 (Flash Bank 2 PCROP zone is kept when RDP level regression (change from level 1 to 0) occurs) 

   DTCM RAM Protection:

     ST_RAM_SIZE  : 0x0 (2 KB) 

   Write Protection:

     nWRP0        : 0x1 (Write protection not active on this sector) 
     nWRP1        : 0x1 (Write protection not active on this sector) 
     nWRP2        : 0x1 (Write protection not active on this sector) 
     nWRP3        : 0x1 (Write protection not active on this sector) 
     nWRP4        : 0x1 (Write protection not active on this sector) 
     nWRP5        : 0x1 (Write protection not active on this sector) 
     nWRP6        : 0x1 (Write protection not active on this sector) 
     nWRP7        : 0x1 (Write protection not active on this sector) 
     nWRP8        : 0x1 (Write protection not active on this sector) 
     nWRP9        : 0x1 (Write protection not active on this sector) 
     nWRP10       : 0x1 (Write protection not active on this sector) 
     nWRP11       : 0x1 (Write protection not active on this sector) 
     nWRP12       : 0x1 (Write protection not active on this sector) 
     nWRP13       : 0x1 (Write protection not active on this sector) 
     nWRP14       : 0x1 (Write protection not active on this sector) 
     nWRP15       : 0x1 (Write protection not active on this sector) 
