Insights
Is it working, and what could be better?
Savings
What Warmcast saves, measured against the same house, the same weather and the same comfort, heated the way it was before. In Shadow mode it will show what it would have saved. No figure is shown until the model has proved accurate.
Recommendations
Changes that would lower your cost or the electricity you use without losing comfort, such as a lower hot water setting or the best way to dry today's washing. Each one will show what Warmcast looked at, how it weighed it up, and what it suggests. Nothing changes unless you change it.
Loading…
Heat loss and what the house stores
How much heat the house loses at each outdoor temperature, how long it coasts on stored heat, and what the sun is worth to each room. These need an accepted fitted model and the planned display. See the learning status above for what is still needed; this view has no promised release date.
Loading heating curve…
Hot water
Loading tank readings…
System schematic
Live readings show where the water is going. Missing or unbound sensors stay labelled as unavailable.
Loading readings…
Loading…
Loading…
Room and outdoor temperatures, last 24 hours
Each room's air temperature as its thermostat reports it. The dashed line is the outdoor temperature.
Heat output, last 24 hours
The heat sensor measures all the heat the heat pump makes, in kilowatts. When the hot water valve reading is available, heat sent to the hot water tank is shown as its own line, apart from space heating. Older readings, from before the valve was logged, cannot be split, so they are shown as total heat with hot water not separated. If the valve reading is missing at a time, both lines have a gap there.
Heat can read low, or below zero, for a few minutes at a time. This happens during defrost, when the heat pump briefly reverses to clear ice from the outdoor unit, and it is expected. The readings are shown exactly as measured.
Defrost (heat pump briefly reverses to clear ice; heat reads low or negative)